Millex®-HV 13mm DURAPORE® PVDF .45um Non-sterile [Pack of 1000]

Description

These syringe filters are recommended for filtering 1–10 milliliter (mL) volumes to remove particles prior to instrumentation analysis. The single-use, disposable filter removes particles larger than the membrane’s
rated pore size.
The Millex® syringe filter consists of a membrane sealed in a polypropylene housing. For details on the type of membrane in your Millex® filter, refer to the table below. The syringe filter is available with either a male Luer-slip outlet or an extended tube outlet. The extended tube outlet facilitates filtration into and out of cuvettes, small volume autosampler vials, and vial inserts by eliminating airlocks.

Chemical Compatibility
Millex® syringe filters are compatible with aqueous, mild organic, and organic solutions. You can use them to filter the agents listed in the following table. This information was developed from technical publications, materials suppliers, and laboratory tests, and is believed to be accurate and reliable. However, because of variability in temperature, concentrations, exposure time, and other factors beyond our control that may affect the use of the unit, no warranty is provided or implied with respect to such information. Agents not listed in the following table should be tested with the Millex® syringe filter prior to use.

NOTE: For low extractable HPLC instrumentation analysis applications, it is recommended that you discard the first 1 mL or rinse with 1 to 2 mL of primary solvent before sample filtration.

How to Use 13 mm Millex® Syringe Filters

WARNINGS:
• The 13 mm Millex® syringe filter is intended for laboratory use only and is not a medical device for direct patient care applications.
• Do not use with syringes smaller than 10 mL because pressures in excess of the maximum pressure rating may be reached, potentially causing damage to the filter unit and/or personal injury.

CAUTIONS:
• Do not use the syringe filter at temperatures above 45 °C (113 °F).
• Do not use the same 13 mm syringe filter to filter solutions in both directions.
• Do not reuse the syringe filter.
• Do not use the syringe filter to filter emulsions or suspensions.
• Perform a binding study before use if there is a concern about loss of analyte (proteins, nucleic acids, active pharmaceuticals) due to binding.